Ford / Mercury / Lincoln Band-Mounted Sensor Re-Learn Instructions
The instructions below can be used for the following vehicles: 2008 Ford Crown Victoria / Lincoln Town Car / Mercury Grand Marquis 2008 Ford E-series 2007-2009 Ford Edge / Lincoln MKX 2005-2008 Ford...
View Article2004 Cadillac CTS Primary Camshaft Drive Chain and Sprockets Replacement
download Primary Camshaft Drive Chain and Sprockets Replacement Removal Procedure 1. Remove the spark plugs in order to ease crankshaft/engine rotation. 2. Remove the engine front cover. 3. Remove the...
View Article2000 Hyundai Elantra GLS Wagon Power Steering Line/Hose: Service and Repair...
download While installing the tube and hose assembly, be sure to align white marks on each fitting. Pressure Hose and Tube 1. Remove the air intake hose assembly. 2. Detach the pressure hose mounting...
View Article1998 Ford F-150/250 Synchronizer Camshaft 4.2L REMOVAL AND INSTALLATION
download Removal 1. Disconnect the battery ground cable. 2. Remove the camshaft position sensor (CMP sensor) (6B288); refer to Camshaft Position (CMP) Sensor—4.2L in this section. 3. Remove the exhaust...
View Article1998 Ford Contour Camshaft Removal Installation
download CAUTION: The maximum amount by which the engine management system will adjust the camshaft timing (VCT control unit) is limited to 2 degrees. As a result of this an extremely high degree of...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article2002 Ford Windstar Camshaft Synchronizer REMOVAL AND INSTALLATION
download Removal 1. Disconnect the battery ground cable. For additional information, refer to Section 414-01. 2. Drain the cooling system. For additional information, refer to Section 303-03. 3. Remove...
View Article
More Pages to Explore .....